Two-part molds are easy with silicone; you just cut the mold in half.
Here, watch this video:
If you want a rubbery end product, you can actually pour silicone into your silicone mold to make a rubbery cast; you just have to make sure you spray your mold first so you can get the cast out.
My bubble problem was not resolvable by any amount of tapping or prodding; when little bits of air get trapped in nooks and crannies. The professional solution is to put the whole thing inside a vacuum chamber, but I don't have one on hand

. (although, I was messing around with one at work today, but I I don't think they'd take kindly to me 'borrowing' it for making toys!

) The best solution is to just have a very low viscosity resin, but I don't know where to get it yet.
***Open for trade!*** looking for: 1993 case collar, mail-order puppies basket handle, and boxes and back cards
Wish list: